MicroTouch Systems FPD Touch Monitor Specifikace stáhnout pdf (Strana 103)

Appendix C TouchPen Controllers 103

TouchPen Diagnostics

TouchPen controllers do not have an LED. You can, however, use

the Unit Type command to obtain status information on the controller

hardware.

Connectors and Cabling

Figure 5 shows the layout of the TouchPen controller and connectors.

Table 20 describes the pins on each connector.

Table 20. Connectors and I/O Signals for the TouchPen Controller

Connector Description Pin Definitions

Pen OFNA R-06

(6-pin, 2 mm)

Connects to OFNA

PH-06 housing with

3222PS-2 pins

Pin 1: Ground (supplied to pen)

Pin 2: Pen Tip signal

Pin 3: Tip switch (data bit S0)

Pin 4: Side switch (data bit S1)

Pin 5: Switch 3 (data bit S2)

Pin 6: Shield drive (supplied to pen)

Sensor Molex 53015 series

(mates with Molex

51004 series)

Pin 1: Upper left (UL) corner

Pin 2: Upper right (UR) corner

Pin 3: Shield drive (supplied to sensor)

Pin 4: Lower right (LR) corner

Pin 5: Lower left (LL) corner

Pin 6: Ground (supplied to controller)

COM

and Power

Molex 53015 series

(with 7 pins)

Pin 1: +12 to +16 VDC power input

Pin 2: Ground (supplied to controller)

Pin 3: RXD (data input to controller)

Pin 4: TXD (data output from

controller)

The MicroTouch standard TouchPen

controller does not use Pin 5 – Pin 7.

The pin definitions are as follows:

Pin 5: -12 to -16 VDC power input

Pin 6: +5 VDC power input

Pin 7: HSYNC input

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 120 121

Komentáře k této Příručce

Žádné komentáře

MicroTouch Systems FPD Touch Monitor Specifikace Strana 103

Komentáře k této Příručce

Související produkty a manuály pro Televizory a monitory MicroTouch Systems FPD Touch Monitor